Article,

The adsorption of CO, O2, and H2 on Pt: I. Thermal desorption spectroscopy studies

, and .
Surf. Sci., 69 (1): 85 - 113 (1977)
DOI: DOI: 10.1016/0039-6028(77)90163-7

Abstract

Thermal desorption spectroscopy (TDS) has been used to study the chemisorption of CO, O2, and h2 on Pt. It has been found that TDS is quite sensitive to local surface structure. Three single crystal and two polycrystalline Pt surfaces were studied. One single crystal was cut to expose the smooth, hexagonally close-packed plane of the fee Pt crystal (the (111) surface). The other two single crystals were cut to expose stepped surfaces consisting of smooth, hexagonally close-packed terraces six atoms wide separated by one atom high steps (the 6(111) � (100) and 6(111) � (111) surfaces). Only one predominant desorption state was observed for CO and H adsorbed on the smooth (111) single crystal surface, while two predominant desorption states were observed for these gases adsorbed on the stepped single crystal surfaces. The low temperature desorption states on the stepped surfaces are attributed to desorption from the terraces, while the high temperature desorption states are attributed to desorption from the steps. TDS of CO from the polycrystalline foils exhibited some desorption states which were similar to those observed on the stepped single crystal surfaces, indicating the presence of adsorption sites on the polycrystalline foils that were similar to the terrace and step sites on the stepped single crystals. In general, these results suggest a high density of defect sites on the polycrystalline foils which can not be attributed simply to adsorption at grain boundaries. Oxygen was found to adsorb well on the stepped single crystals and on the polycrystalline foils, but not on the smooth (111) single crystal, under the conditions of these experiments. This is attributed to a higher sticking probability for dissociative O2 adsorption at steps or defects than on terraces.

Tags

Users

  • @jfischer

Comments and Reviews