%0 Journal Article %1 Kuhn:December2002:0375-6505:725 %A Kühn, M. %A Bartels, J. %A Iffland, J. %D 2002 %J Geothermics %K 2002 anhydrite sandstones simulation %P 725-749(25) %R doi:10.1016/S0375-6505(02)00033-0 %T Predicting reservoir property trends under heat exploitation: interaction between flow, heat transfer, transport, and chemical reactions in a deep aquifer at Stralsund, Germany %U http://www.ingentaconnect.com/content/els/03756505/2002/00000031/00000006/art00033 %V 31 %X The subsurface flow and hydrogeothermal simulation system SHEMAT (Bartels, J., Kuhn, M., Pape, H., Clauser, C., 2000. A new aquifer simulation tool for coupled flow, heat transfer, multi-species transport and chemical water-rock interactions. In: Proceedings World Geothermal Congress 2000, Kyushu - Tohuku, Japan, May 28 - June 10, pp. 3997-4002) is used to investigate a typical hydrothermal sandstone reservoir situated in the North German Basin. This study focuses on the prediction of long-term behavior of reservoir properties for the entire operation time with reinjection during heat exploitation for district heating. The Stralsund location in NE Germany and the Detfurth sandstone horizon (Buntsandstein) are chosen due to the combination of its already confirmed geothermal potential and the availability of a complete data set. An installation of two production wells and one well for reinjection implements heat exploitation. Reinjection is required due to high salinity of the water. In order to quantify injectivity changes and allow the separation of thermal from chemical effects, changes in the hydraulic parameters of the reservoir are at first studied without chemical reactions. Reinjection of cooled water of higher viscosity than the natural reservoir fluid leads to a continuous reduction of the injectivity. This effect is partially balanced by thermally induced mineral reactions. Dissolution of anhydrite in the vicinity of the injection well dominates the effect of anhydrite precipitation at the propagating thermal front leading to a net increase of injectivity. Observed calcite precipitation around the injection well and dissolution at the thermal front are too small to alter reservoir properties significantly. Coupled numerical simulation indicates that the injectivity of the reservoir is influenced primarily by the viscosity effect, but that mineral reactions weaken this negative trend. Operation of a geothermal heating plant at the Stralsund location would not be restricted by a long-term reduction in the injectivity of the reinjection well.

@article{Kuhn:December2002:0375-6505:725, abstract = {The subsurface flow and hydrogeothermal simulation system SHEMAT (Bartels, J., Kuhn, M., Pape, H., Clauser, C., 2000. A new aquifer simulation tool for coupled flow, heat transfer, multi-species transport and chemical water-rock interactions. In: Proceedings World Geothermal Congress 2000, Kyushu - Tohuku, Japan, May 28 - June 10, pp. 3997-4002) is used to investigate a typical hydrothermal sandstone reservoir situated in the North German Basin. This study focuses on the prediction of long-term behavior of reservoir properties for the entire operation time with reinjection during heat exploitation for district heating. The Stralsund location in NE Germany and the Detfurth sandstone horizon (Buntsandstein) are chosen due to the combination of its already confirmed geothermal potential and the availability of a complete data set. An installation of two production wells and one well for reinjection implements heat exploitation. Reinjection is required due to high salinity of the water. In order to quantify injectivity changes and allow the separation of thermal from chemical effects, changes in the hydraulic parameters of the reservoir are at first studied without chemical reactions. Reinjection of cooled water of higher viscosity than the natural reservoir fluid leads to a continuous reduction of the injectivity. This effect is partially balanced by thermally induced mineral reactions. Dissolution of anhydrite in the vicinity of the injection well dominates the effect of anhydrite precipitation at the propagating thermal front leading to a net increase of injectivity. Observed calcite precipitation around the injection well and dissolution at the thermal front are too small to alter reservoir properties significantly. Coupled numerical simulation indicates that the injectivity of the reservoir is influenced primarily by the viscosity effect, but that mineral reactions weaken this negative trend. Operation of a geothermal heating plant at the Stralsund location would not be restricted by a long-term reduction in the injectivity of the reinjection well.}, added-at = {2009-09-28T18:07:31.000+0200}, author = {Kühn, M. and Bartels, J. and Iffland, J.}, biburl = {https://www.bibsonomy.org/bibtex/25ef5f4c6b802e7f95e70d891860a2911/schepers}, description = {IngentaConnect Predicting reservoir property trends under heat exploitation: int...}, doi = {doi:10.1016/S0375-6505(02)00033-0}, interhash = {54062592eea034b3dd8294157533c0a7}, intrahash = {5ef5f4c6b802e7f95e70d891860a2911}, journal = {Geothermics}, keywords = {2002 anhydrite sandstones simulation}, pages = {725-749(25)}, timestamp = {2009-09-29T17:27:57.000+0200}, title = {Predicting reservoir property trends under heat exploitation: interaction between flow, heat transfer, transport, and chemical reactions in a deep aquifer at Stralsund, Germany}, url = {http://www.ingentaconnect.com/content/els/03756505/2002/00000031/00000006/art00033}, volume = 31, year = 2002 }